1 Physics -- Interference

If one of the slits of Young's Double Slit experiment is immersed in water, what happens to the fringe pattern?

1 Answers

If one of the slits of the YDSE is immersed in water, it will take more time to travel the same distance. This means, at the same time, the light through water will travel less distance than from the other slit.

We know that the central bright fringe is formed at the point where the path difference will be zero, i.e. the light from both the slits will cover the same distance. In order to have zero path difference, the central fringe should shift to the side of the water by a distance of Δx = D(μ-1) t/d.

Other fringes will also follow the suit. This shifts the whole pattern towards the side of the slit which was immersed in water.

Two batteries of emf 4V and 8V and internal resistance of 1 ohm and 2 ohms respectively connected in a series with resistance if 9 ohms as shown in the figure. Calculate the current and potential d...

Applying Kirchhoff's voltage law
8 -4 -1I - 2I=0I=13A
Potential difference acrossPQ=139=3V

Find VH using Kirchoff's voltage law.

If one of the slits is covered in Young's Double Slit experiment, what changes occur in the intensity of light in the center of the screen?

In interference, the amplitude of the central bright fringe is double the amplitude of light given by the two coherent sources.
we know, intensity is directly proportional to the square of the amplitude of light.

i.e. Iα A²

So, the intensity of central bright fringe is four times the intensity of light passing through each slit.
i.e. Intensity of light of central bright fringe = 4 X intensity of light through each slit.

Hence, when one slit is covered in YDSE, the central bright fringe will...

When a glass plate is used to cover both slits in Young's Double Slit experiment, what happens to the fringe pattern?

If a glass plate is used to cover both the slits in Young's Double Slit Experiment, the speed of light passing through the slit decreases. And, we knowλ = v / f. Since the frequency of light remains constant, the wavelength decreases with the decrease in the velocity of sound.
We also know that the fringe width is given by

β =λD/d
where,
D= distance between slit and screen
d= slit width

Since D and d remain constant in the above relation, fringe width is directly proportional to the wavelength of...

What will be the effect on the interference fringes obtained in Young's Double Slit experiment if the monochromatic source of light is replaced by white light source?

If the monochromatic source of light in Young's Double Slit experiment is replaced by a white light source, then we can obtain colored fringes due to the overlapping of the components of the white light. The central maxima will appear white because no overlapping occurs there rest fringes are colored. As the fringe width for violet colour light is least and that of red light maximum first minima for violet light will come first and the fringe will appear red there. Slightly farther away where...

In a laboratory accident, you spill two liquids onto water, neither of which mixes with it. They both form thin films on the water surface. As the films spread and become thin, you notice that one ...

When two waves going in the same direction have the same phase or phase difference, constructive interference occurs and they give a bright fringe or zone. If they are of opposite phases, they result in destructive interference and cause darkness. The same event occurs for waves reflected from the upper a lower layer of the oil films

For some films (which are not uniform), the thickness might be equal to or an integral multiple of a certain wavelength present (depending on the thicknesses),...

ask mattrab